TABLAS · TABLES · TABELAS ·
19
10
PROBLEM POSSIBLE CAUSES HOW TO PROCEED
Device does not turn on Blown fuse Replace the fuse. Disconnect any other
electrical appliances connected to the fuse.
The electrical current is
not on
Make sure the dishwasher is on and the
door is closed. Make sure that the plug is
connected to the mains.
Low water pressure Make sure that the water inlet hose is
correctly positioned and the water faucet
is open.
Door of dishwasher not
properly closed
Make sure to close the door properly and
latch it
Non fucnion drainage pump Twisted or trapped drain
hose
Check the drain hose.
Filter clogged Check the lter system.
Kitchen sink clogged Check the kitchen sink to make sure it is
draining well. If the problem is the kitchen
sink that is not draining , you may need
a plumber rather tan a serviceman for
dishwashers
Foam in the tub Wrong detergent Use only the special dishwasher detergent
to avoid suds. If this occurs, open the
dishwasher and let suds evaporate. Add
1 liter of cold water to the bottom of the
dishwasher. Close the dishwasher door, then
select any cycle. Initially, the dishwasher
Will drain out the water. Open the door after
draining stage is complete and check if the
suds have disappeared. Repeat if necessary
Spilled rinse aid Always wipe up rinse aid spills immediately
Stained tub interior Detergent with colourant
may have been used
Make sure that the detergent has no
colourant
White lm on inside surface Hard water minerals To clean the interior, use the damp soft
cloth with dishwasher detergent and wear
rubber gloves. Never use any other cleaner
than dishwasher detergent otherwise, it
may cause foaming or suds
There are rust stains on cutlery The affected items are not
corrosion resistant
Avoid washing items that are not corrosion
resistant in the dishwasher
A program Always run a wash program without any
crockery after adding salt. Do not select
the Turbo function (if present), after adding
dishwasher salt.
was not run after Check the softener lid is secure