EasyManua.ls Logo

universalblue JAVA 5045W - Page 51

universalblue JAVA 5045W
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EN
51
69. Teaspoons
70. Dessert spoons
71. Serving spoons
72. Serving forks
73. Gravy ladles
In order to avoid danger of
injury, place long and pointed
parts as well as knives in such
a way that they cannot cause
damage.
Do not let any item extend
through the bottom. Always
load sharp utensils with the
sharp point down!
Do not include the following utensils in
your dishwasher:
Porcelain cutlery of wood, horn or
mother-of-pearl handles
Plastic items that are not heat-resistant
Old cutlery with glued parts that are not
temperature resistant
Adhered cutlery or plates
Copper articles
Steel elements subject to oxidation
Wooden trays
Synthetic bre elements
Some types of crystal can
become opaque after a large
number of washes. Silver
pieces have a tendency to fade.
Glazed patterns can fade if
washed frequently.
Do not put items that are soiled
with cigarette ash, candle wax,
lacquer, or paint. If you buy
new dishes, please make sure
they are dishwasher safe.
Please do not overload your
dishwasher. Otherwise,
optimum results will not be
obtained and the device may
break down.
Note: Very small items should not be
washed in the dishwasher as they could
easily fall out of the basket.
Removing the dishes
To prevent water dripping from the
upper basket into the lower basket, we
recommend that you empty the lower
basket rst, followed by the upper basket.
Items will be hot! To prevent damage,
do not take glass and cutlery out of the
dishwasher for around 15 minutes after the
program has ended.
PROGRAMS TABLE (See table 04 on page
14).
WITCHING THE DEVICE ON AND OFF
Turn on the dishwasher
Open the dishwasher baskets and insert
the dishwasher. It is recommended to
load the lower basket rst.
Add detergent.
Connect the device to the light,
observing the voltage instructions of
the device.
Make sure the water supply is
connected to maximum pressure. Close
the dishwasher door and press the
“Power” button.
Press Program button to select the
desired wash cycle.
Starting a program
Draw out the lower and upper basket,
load the dishes and push them back. It
is commended to load the lower basket
rst, then the upper one.
Pour in the detergent.
Insert the plug into the socket.Close the
door, press the Power button.
Choose a program, the response light
will turn on.
Change the selected program
A cycle that is running can only be
changed if it has been running for short
time. Otherwise, the detergent may have
already been released and the appliance
may contain water. If this is the case,
the dishwasher needs to be reset and the
detergent dispenser must be relled. To
reset the