EN
53
the lter. (see image 23 on page 11).
74. Hold the coarse lter and rotate it
2 anticlockwise to unlock the lter.
Lift the lter upwards and out of the
dishwasher.
75. The ne lter can be pulled off
the bottom of the lter assembly. The
coarse lter can be detached from the
main lter by gently squeezing the
tabs at the top and pulling it away.
• Main lter
• Coarse lter
• Fine lter
76. Larger food remnants can be 4
cleaned by rinsing the lter under
running water. For a more thorough
clean, use a soft cleaning brush.
77. Reassemble the lters in the
reverse order of the disassembly,
replace the lter insert, and rotate
clockwise to the close arrow.
Note: Pictures are only for reference,
different models of the ltering system and
spray arms may be different
Do not over tighten the lters.
Put the lters back in sequence
securely, otherwise coarse
debris could get into the system
and cause a blockage.
Never use the dishwasher
without lters in place.
Improper replacement of the
lter may reduce the
performance level of the
appliance and damage dishes and utensils.
Spray arms
It is necessary to clean the spray arms
regularly for hard water chemicals will
clog the spray arm jets and bearings.
To clean the spray arms, follow the
instructions below (see image 24 on page
11):
78. To remove the upper spray arm,
hold the nut, rotate the arm clockwise
to remove it.
79. To remove the lower spray arm,
pull out the spray arm upward.
80. Wash the arms in soapy and warm
water and use a soft brush to clean the
jets. Replace them after rinsing them
thoroughly.
CARING FOR THE DISHWASHER
Frost precaution
Please take frost protection measures on
the dishwasher in winter. Every time after
washing cycles, please operate as follows:
• Cut off the electrical power to the
dishwasher at the supply source.
• Turn off the water supply and
disconnect the water inlet pipe from
the water valve.
• Drain the water from the inlet pipe and
water valve. (Use a pan to gather the
water)
• Reconnect the water inlet pipe to the
water valve.
• Remove the lter at the bottom of the
tub and use a sponge to soak up water
in the sump.
After every wash
After every wash, turn off the water supply
to the appliance and leave the door slightly
open for a while so that moisture and odors
are not trapped inside.
Remove the plug
Before cleaning or performing
maintenance, always remove the plug
from the socket.
No solvents or abrasive cleaning
• To clean the exterior and rubber parts of
the dishwasher, do not use solvents or
abrasive cleaning products. Only use a
cloth with warm soapy water.
• To remove spots or stains from the
surface of the interior, use a cloth
dampened with water an a little
vinegar, or a cleaning product made
specically for dishwashers.
When not in use for a long time
It is recommend that you run a wash cycle
To Next Page
Loading...