2
1. Installation of Unovent® h-line
™
system for rooms with no
roof cavity requires a degree of skill and experience to
ensure no damage is done to existing wall framing and
electrical power cables. It is the responsibility of the
installer and the home owner to ensure correct
procedures are followed when installing any through-the-
wall device and to ensure that the finished installation
does not allow the ingress of water into the external wall
structures. If uncertain about the critical requirements
when installing devices which penetrate external walls, do
not attempt such work until that uncertainty is removed.
Alternatively, utilise the services of a qualified trades
person who understands the requirements to prevent
ingress of water into the external wall structures.
(Unovent Limited does not take any responsibility for the
finished water tightness or otherwise for the installation.)
2. Decide where you plan to install the outer wall mounted
Unovent® room outlets in each room selected. These
should be living spaces, such as bedrooms, lounges,
family rooms and dining rooms.
3. The first stage of this planning is to simply decide on the
preferred locations where the 240mm holes are to be cut
in the wall lining for mounting the Unovent® room outlets.
Do not actually start cutting holes at this point – that will
be described later in this instruction.
4. For the bedrooms, lounge rooms, family rooms and dining
rooms, select the position on the wall near the window
and the ceiling where you expect the hole to be cut to take
the Unovent® room outlet.
To Next Page
Loading...
Need help?
General