90*85mm
LED LIGHT
LED LIGHT
User Manual
LED LIGHT
OFF-Road
Made in China
www.ursprung-veh.com support@ursprung-veh.com
Product Overview
Lamp Body
Connector
Product Specification
TYPE:
Operating Voltage:
IP Rate:
Product Features
Frequently Asked Questions
LED Chips
Locking Ring
Heat Sink
Package Contents
Pack of 2
LED Bulb (I pair)
User Manual x I
Gloves (I pair)
Pack of 4
LED Bulb (2 pairs)
User Manual * 1
Gloves (1 pair)
K30
DC12V
IP6B
Color Temperature:
Luminous Efficiency :
Operating Temperature:
6500K
-490 - 3020F
1.
3.
4.
S.
1. Perfect beam pattern, no dark spots or foggy light.
2. CANbus-Ready and works with most vehicle system without error.
What bulb size do I need for my vehicle?
It depends on the original bulb installed, if you are not sure Which bulb size fits your vehicle, please
check your vehicle hand book or the part number on your original bulbs, you can also search
•Automotive Bulb Guide" online or check With us.
installed your bulbs but they do not turn on?
We first would highly recommend checking your fuses, if the fuses are good next we would recommend
putting back the stock bulbs to see if they ight up, if they do light up then the bulbs may be defective,
however, we recommend installing the bulbs with decoders first before declaring the bulbs defective
Why is my bulb flickering/dimming or dashboard error message occurring?
Your vehicle's computer system may recognize the low power draw ot the LED bulb as a problem or
fault. It may cause a bulb out indicator on your dashboard and sometimes cause the bulb to flicker or
dim A load resistor or CANbus decoder should be installed to solve this issue
How do I know if my vehicle requires extra CANbus decoders to be installed?
You might need to get the extra decoder if the following problems persist with your car after an LED
installation:
The bulbs keep flashing when you try to switch on the bulbs.
The car's computer system keeps indicating an error.
The bulbs stay lit for a while even after you have switched them off
The bulbs give Off a dim light unlike the bright throw Of LEDs
How does a CANbus decoder work?
The technology of the decoder is not only to increase the wattage of the LED bulbs but send a signal to
the CANbus system Of the car. Most Of the times the afterpart LED bulbs fail to work because their
power does not reach the minimum requirement of the installed CANbus system
3. Easy to install, plug and play.
www.ursprung-veh.com support@ursprung-veh com www.ursprung-veh.com E support@ursprung-veh.com
To Next Page
Need help?
General
