Page 21
CONNECTORS
Connecting load cells to the indicator
• The indicator can connect with 6 load cells of 350Ω at most
• 4 wire or 6 wire load cell connections are both okay
• Please contact us directly if you have other special needs for your application
There are two connection methods between the load cell and indicator Quick Disconnect as
shown below:
Hardwire (Using Inner Terminal Block Connection:
Note: Make sure you follow all the anti-static rules to avoid damage to your indicator
• Excitation voltage: 5V DC
• Largest output current: 120 mA
• Excitation circuit: 5 VDC, 4 wire connection, 6 load cell of 350ohm maximum
• Open the back cover of the weighing indicator, and insert signal cable to the terminal
block; Make sure the screw on terminal block is xed tightly.
To Next Page
Loading...
