12
WEIGHING/PRINTING MODES
In the Parameters you can set to have your printer print automatically or manually, we
recommend setting to manual (F3 [PM - 0]) for best results.
Normal Weighing mode:
● In the F3 menu set the Printing Format to “1” [
PF - 1
]
● In this mode you have the option of using 1-4 pads [
ModE 3
]
Example : There are 3 weighing pads connected to the indicator to weigh an airplane.
1. The pads should connect with LFW,LRW,RRW interfaces
2. Parameter settings: F1 Working Mode setting: “3” [
ModE 3
]
F3 Printing Format setting: “1” [
PF - 1
]
3. Drive the plane on the pads. You can press the “SWITCH” key to switch between
displaying the total weight, and the weight of each pad, shown with the
percentage of that pads load of the total weight
● If [PM - 1] Printing and Saving will be done automatically once the load is stable
● If [PM - 0] Press the “PRINT” key to print results
To Next Page
Loading...
