Need help?Do you have a question about the USAG 907 N and is the answer not in the manual?
General| Type | Torque Wrench |
|---|---|
| Model | 907 N |
| Manufacturer | USAG |
| Torque Range | 20-100 Nm |
| Drive Size | 1/2 in |
Details on using the timing light for 2/4 stroke engines, RPM, advance, dwell, and injection time measurements.
Lists systems like breaker points, advance mechanisms, and vacuum systems for fault diagnosis.
Softly coil cables, never wrap them around the timing light to prolong its lifetime.
Connect timing light, mount clamp 10cm from distributor, arrow towards spark plug, keep cables clear.
Procedure for checking dwell angle in breaker points or transistorized ignition systems.
How to read RPM up to 19990 via inductive clamp or up to 6000 RPM with stroboscope.
Procedure for checking ignition timing advance against manufacturer data.
Procedure for measuring centrifugal advance at specified engine speeds.
How to check the vacuum advance function by connecting a vacuum tube.
Procedure for checking acceleration retard in engines equipped with this device.
How to measure battery voltage, alternator charge, sensors, and peak voltage.
Procedure for checking breather pipes for occlusions or valve damage.
How to check the mechanical position of timing marks on engine components.
Instructions to press RESET if the display shows faults during connection or operation.
To Next Page