To Next PageTo Next Page
Need help?Do you have a question about the USG Durock and is the answer not in the manual?
General| Brand | USG |
|---|---|
| Model | Durock |
| Category | Bathroom Fixtures |
| Language | English |
Apply code-approved substrate and thin-set mortar for shower wall installation.
Embed DUROCK™ Shower System Waterproofing Membrane into mortar using a finishing trowel.
Ensure adjoining membrane sections overlap a minimum of 2 inches for proper sealing.
Install DUROCK™ Shower System Waterproofing Band at vertical inside wall corners.
Apply thin-set mortar and embed DUROCK™ Pipe Seal to pipe penetrations for waterproofing.
Apply thin-set mortar and embed DUROCK™ Mixing Valve Seal in openings for waterproofing.
Prepare shower tray and subfloor, including tracing drain hole and applying mortar.
Embed the DUROCK™ Pre-Sloped Shower Tray into mortar and position correctly.
Install DUROCK™ Drain Assembly into the tray, ensuring proper alignment and bonding flange support.
Apply waterproofing band, membrane, and preformed corners to junctions with curbs.
Install the DUROCK™ Grate Assembly into the grate tray riser, aligning with floor tile.
