8-56
System Menu > Default Setting on the Machine (System Menu)
*1 Displayed only when the optional fax kit is installed.
*2 This is displayed when the optional Card Authentication Kit is installed.
Sleep Level (models except for
Europe)
Select the sleep level.
Set the Energy Saver mode to reduce power consumption even more than normal Sleep mode.
Value: Quick Recovery, Energy Saver
When the machine has entered sleep mode with Energy Saver setting, it does not wake from
sleep mode when it receives print data from a PC connected by USB cable. Also, the ID card
cannot be recognized.
EnergySaver RecoveryLevel Select the method of recovery from energy saver.
Value:
Full Recovery: This mode enables the use of all functions immediately.
However, this mode saves less energy.
Normal Recovery: In this mode, you can select the method from the following:
enabling the use of all functions immediately or enabling the use of
desired functions only.
If you want to use all functions immediately, press the [
Power] key
to execute recovery.
Power Saving Recovery: This mode enables the use of desired functions only. This
mode saves energy most effectively.
Weekly Timer Settings Configure settings for switching the machine into Sleep mode and waking it automatically at a
specified time for each day of the week.
Weekly Timer Select whether to use Weekly Timer.
Value: Off, On
Schedule Specify the time for each day of the week at which the machine enters Sleep mode and
recovers.
Retry Times Set the number of retry to switch the machine into Sleep mode.
Value: Limited Retries, Unlimited Retries
If [Limited Retries] is selected, set the number of retry. The setting range is 0 to 10. Retry is not
performed when "0" is set.
If [Unlimited Retries] is selected, retry is performed until the machine enters Sleep mode.
Retry Interval Set the retry interval.
Use [-] / [+] to enter a number.
Value: 10 to 60 seconds (increments of 10 seconds)
Item Description
To Next Page
Loading...
