08EN
NOTE
：
When adjusting the clamps please be sure to disconnect your Jump
Starter rst. This will prevent the occurrence of minor sparks.
How to jump start your car
Step 1:
Insert the plug of the battery clamps completely into the jump starter,
the red and green lights ashing alternately.
Step 2:
Connect the red clamp to the positive electrode (+) of the car battery
and the black clamp to negative one (-). The green light is always on.
• When using the clamps, do not allow the metal teeth of the black clamp to
touch the metal teeth of the red clamp.
• When using the clamps, DO NOT connect the RED clamp to the vehicle
battery’s negative (-) terminal, or the BLACK clamp to the vehicle battery’s
positive (+) terminal.
• When connecting smart clamps to the battery terminals, ensure the copper
teeth on each side of the clamp make good contact with the terminal. The
better the connection, the easier it will be to start your vehicle.
RED BLACK
To Next Page
Loading...
