Need help?Do you have a question about the Vaderstad RAPID RDA S Series and is the answer not in the manual?
Procedures for connecting and disconnecting the seed drill from the tractor.
Procedures for changing the drill between transport and working configurations.
How to adjust the drill for level operation in the field.
Setting and adjusting the sowing depth using the master/slave hydraulic system.
Adjusting the weight transfer system for optimal ground pressure.
Adjusting the tool bars for correct operating angle and depth.
Adjusting the seed rate using the scale for mechanical feed systems.
Setting seed boxes for hydraulic feed systems based on the sowing table.
Performing calibration tests for mechanical seed feed systems.
Conducting calibration procedures for hydraulic seed feed systems.
Performing tests to verify the drill's actual feed rate.
Adjusting fan speed and airflow for optimal seed distribution.
Overview and functional description of the Control Station interface.
Setting the work angle and pressure of the following harrow.
Setting the low lift height for proper operation and clearance.
Securing lifting rams with locking devices during maintenance.
Adjusting seed coulters for correct installation height and disc contact.
Importance of checking and adjusting sowing depth for optimal germination.
Procedures to verify uniform seed delivery from all coulters.
Steps to lower and engage the drill for sowing operation.
Key considerations for using tramlining, including Autostep function.
Setting and checking bout markers for accurate guidance.
Chart and guidelines for lubricating various points on the drill.
Procedure for safely changing drill discs and adjusting coulters.
Replacing seals on master, slave, and other hydraulic rams.
Procedures for draining oil and bleeding accumulators.
General approach to diagnosing and resolving faults in the drill's systems.
To Next Page
General