Clean the hydraulic couplings
Make sure that the couplings are clean and check colour markings.
Check wear on hitch pin & safety chain
If the hitch pin shows signs of wear or damage it will need to be serviced/replaced.
Order new wear parts in time
Check seed and fertilizer knives for wear – if carbides are worn off they need replaced.
Adjust when necessary. Tighten hose clamps.
Castors
Check castor plate to weldment gap is less than 1/8”. Adjust as required.
Shanks
Check condition and torques throughout the toolbar. Consult the operator’s manual for
torque specs.
Air pack & manifold
Check for defects and/or damage. Turn primary hoses as necessary.
Towers & secondary hoses
Look for loose hardware. Tighten as required. Check for kinked hoses, replace as
necessary.
1
1
2
3
4
Seed Hawk XL toolbar
5
6, 7, 8
9
6
10 11, 12
2
1
3
5
4
7
Seed Hawk toolbar
To Next Page
Loading...
