Adapting the appliance to the heating system
88 Installation instructions geoTHERM 0020051574_04
9
9.7.4 Menu A: Calling up Installation Assistent
Display shown Description Factory setting
Menu A: Calling up Installation Assistent The Installation Assistent appears automatically when
the heat pump is commissioned. You are guided
through the first two menus A1 and A2.
You now have the opportunity to subsequently
change the settings once more.
Installationsassistent
A1
Sprache >DE deutsch
Standort >DE
>Sprache wählen
During the initial ins
tallation the controller always
starts with this menu (Installation Assistent).
Sprache (Language): Set the local language
Standort (Location): (only when a VPM S solar
charging station is installed) By inputting a loca-
tion in the form of a country code, e.g. DE, and
using the time of day established by a DCF
receiver, an internal sun calendar in the solar
station calculates the times of sunrise and sun-
set. Testing the collector temperature by switch-
ing on the solar pump in 10 minute intervals is
suspended at night-time.
Installation Assistent
A2
Appliance Code 5
Hydraulic scheme 6
Electric Wiring Diagram 1
Accept change YES
>Select
The hydraulic and wiring systems must be adjusted by
the installer during commissioning.
i
The Appliance Code has already been set
in the factory and must not be changed.
After resetting to factory settings, you
must re-input the value, where required.
Appliance Code:
Type Designation
11 VWS 220/2
12 VWS 300/2
13 VWS 380/2
14 VWS 460/2
23 VWW 220/2
24 VWW 300/2
25 VWW 380/2
26 VWW 460/2
9.9 Menu A: Calling up Installation Assistent
To Next Page
Loading...
Need help?
General