Opening and Closing the Transmitter
GMW80 series transmitters are delivered from the factory with a pull tab that
makes it easy to open the transmitter for installation.
To open the transmitter after it has been installed:
1. Loosen the locking screw if it has been installed.
2. Use a flat screwdriver to push down the tab that holds the transmitter cover
and mounting base together, and pull the top of the transmitter cover away
from the mounting base.
Be careful when opening the transmitter:
n Pushing down too hard can break off the opening tab.
n Inserting the screwdriver too far into the transmitter enclosure
may damage transmitter components.
To close the transmitter:
1. Align the bottom of the transmitter cover with the bottom of the mounting
base.
2. Tilt the top of the transmitter cover forward until the tab catches with an
audible snap. Note that closing the transmitter starts it up if power is
supplied to the screw terminals.
3. Pull on the cover gently to make sure it is properly closed and not loose.
4. Attach the locking screw if desired.
19
3 Installation
To Next Page
Loading...