Installing the Mounting Base
The transmitters are designed to be installed on a mounting box or directly to a
wall surface.
Use the mounting holes to attach the mounting base securely. Use at least two
screws (not included). The mounting holes are suitable for the most common
European, American, and Asian mounting boxes. The mounting base can be
twisted on to pre-mounted screws.
Figure 13 Installing the Mounting Base
Mounting bases are tailored to the individual transmitter at the
factory. If you attach several mounting bases before connecting
the transmitters, store the transmitters in their original shipping
boxes, so that you can match the serial number on the mounting
base to the serial number on the shipping box.
The arrow on the mounting base must point straight up after
installation. Proper orientation is important: air must flow through
the vents on the bottom and top.
20
3 Installation
To Next Page
Loading...