Vaisala CARBOCAP GMW86P - Wiring GMW83, GMW83 D and GMW83 A

You can also bring the cable to the housing from above or below, but you have
to break off the small plastic tab that covers the hole on top or bottom of the
housing.
Figure 15 Locations of the Breakaway tabs
After completing the wiring, connect the transmitter body over the mounting
base. Note that mounting bases are model-specific.
Wiring GMW83, GMW83D and GMW83A
+
-
18 ... 35 VDC
or 20 ... 30 VAC
Power supply
Controller
Analog signal ground
T signal analog input
(0 ... 10 V)
VS
T
CO2
0...10 V
0...10 V
GND
GMW83
GMW83A
GMW83D
CO
2
signal analog input
(0 ... 10 V)
Figure 16 Wiring for GMW83,GMW83D, and GMW83A
22
3 Installation