88 mm
≥ 10 mm
≤ 8 mm
≤ 3.5 mm
Ø 4 ... 8 mm
Figure 7 HMW110/112 Installation
1. Open the transmitter cover and use two screws (not included) to attach the transmitter to
the wall. The probe and cable gland should point down.
2. Open the transmitter cover, and route the cable through the cable gland. Connect the
wires to the screw terminals according to the wiring instructions.
3. Tighten the cable gland and close the transmitter cover.
4. Remove the yellow transport protection cap from the probe.
More Information
‣
Component Board (page 13)
‣
Wiring Devices With Analog Output (page 24)
‣
Wiring Devices With Modbus Output (page 27)
Chapter 3 – Installation
19
To Next Page
Loading...
