Vaisala HMDW110 - Installation; Wiring Devices With Analog Output; Wiring Both Current Loops With Single Power Supply; HMDW110 Power Supply Requirements

5. Mount the transmitter according to the type of the installation site:
• Pole installation
1. Use the supplied clamp and screws to mount the transmitter on a pole.
2. To prevent the transmitter from turning on the pole, tighten the set screw on the
center hole of the clamp.
• Wall installation
1. Drill two holes for wall plugs 100 mm apart.
2. Place the wall plugs in the holes.
HMDW110 User Guide M211726EN-D
22