User’s Guide ______________________________________________________________________
56 ___________________________________________________________________ M010056EN-I
FILT Output Filtering
Syntax: FILT [a.aaa]<cr>
This commands sets the measurement result filtering.
Example:
>filt 1
Filter : 1.0000
>filt 0.5
Filter : 0.5000
>filt 0.1
Filter : 0.1000
>
Resetting the Transmitter
RESET Transmitter Reset
Syntax: RESET<cr>
This command resets the device.
NOTE
Conversions from mmHg and inHg are defined at 0 °C.
where
a.aaa = 0.1 ... 1
1=No filtering
0.5 = Average of last two measurements
0.1 = Average of ca. 16 measurements
To Next Page
Loading...
