Vaisala Indigo 202 - Wireless Configuration Interface

1.10 Wireless Interface Menus
Indigo transmitters are configured using a wireless browser-based configuration interface
(requires a mobile device or computer with IEEE 802.11 b/g/n WLAN wireless connectivity).
In addition to probe and transmitter configuration and calibration, you can also use the
wireless interface to view measurement data and status information.
1
2
3
4
5
Figure 8 Wireless Configuration Interface, Desktop Browser View
1 Measurements: displays the measurement data of the connected probe
2 Status: contains information about the status of Indigo and the connected probe (for
example, notifications and alarms)
3 Calibration: calibrate and adjust probes using references. Available options (for
example, adjustment points) vary depending on the probe model.
4 Settings: contains options for configuring the connection and display settings, outputs,
relays, probe-specific settings, and general device preferences
• General submenu: device information and general settings, wireless connection
and display settings
• Outputs submenu: Modbus serial communication settings
• Relays submenu: settings for controlling relays A and B
• Probe submenu:
probe-specific settings such as environmental compensations
and filtering factor
5 Main display area for menus and measurement information (desktop browser example)
You must be logged in as Admin to change settings with the wireless configuration
interface. Logging in as User gives view-only access.
M211967EN-E
14