5.11 Configuring DNP3 protocol
Figure 36 DNP3 settings page
DNP3 protocol is an optional feature and requires a license. If a license is not
installed on the DGA monitor, you cannot enable the protocol. Contact Vaisala for
acquiring the license.
1. In the user interface, select Settings > Network > DNP3.
2. Select if the DNP3 protocol should be Enabled or Disabled.
3. If you enabled the DNP3 protocol, configure the following settings:
Connection type
Interface where DNP3 protocol will be available.
Slave link address
Address of this DGA monitor.
Master link address
Address of the DNP3 master.
Default analog input variation
Data format variation for analog input values. Variations 1 … 6 are available.
Chapter 5 – Commissioning
77
To Next Page
Loading...