Function Description
Optional Polarization Control RS-422 dierential control for polarization switch
Trigger Output Up to 12 total triggers available on various connector pins.
Triggers are programmable with respect to trigger start, trigger width, and
sense (normal or inverted).
9.4 RVP901 IFDR Specifications
Table 75 IF Band Pass Filter
Function Description
IF band pass filter Programmable Digital FIR with software selectable bandwidth.
Built-in, filter design software with user interface.
Table 76 IF Inputs
Characteristic Description
A/D conversion • Resolution: 16 bit with jitter <1.0 picosec
• Sampling rate: 50 ... 100 MHz (software selectable)
Dynamic Range (dependent on
matched filter)
90 ... >105 dB
IF range 5 ... 120 MHz
Impulse response Up to 80 μsec
These very long filters are used with pulse compression.
Input Signals • IF Received Signal: 50 Ω ,+ 8.0 dBm full-scale, +20 dBm absolute max
• IF Burst or COHO: 50 Ω, +8.0 dBm full-scale, +20 dBm absolute max
• Optional Reference Clock: 7.5 MHz ... 100 MHz, -20 dBm ... 6 dBm
Master clock jitter <1.0 picosec
Maximum number of range bins Full unambiguous range at minimum resolution or 4200 range bins
(whichever is less)
Maximum range Up to 1024 km
Minimum range resolution 15 meters
(accuracy of ±1.5 m)
Multiply/accumulate cycles per
second
38.4 billion Hz
Pulse repetition frequency (PRF) 50 Hz ... 20 KHz, , +0.1%, continuously selectable
Range resolution Minimum bin spacing of 25 m, selectable in N*8.33 m steps.
Bins can be positioned in a configurable range mask with resolution of
N* the fundamental bin spacing, or arbitrarily to an accuracy of ±2.2 m.
Chapter 9 – Technical Data
331
To Next Page
Loading...