Vaisala RVP900 - Checking Board Configuration with Setup MC Command; Table 91 Internal Status Setup Checklist; Table 92 Board Configuration Checklist

Test Procedure
1. Enter the TTY setups through dspx.
2. Issue the V command to display the internal status.
Checklist
Table 91 Internal Status Setup Checklist
Task Checked OK/Not OK Remarks
Test procedure completed successfully.
Status information is correct and shows no faults.
See 5.1.2 V and Vz – View Card and System Status (page 89).
Test Passed
For Customer Date:
For Vaisala Date:
A.7 Checking Board Configuration with
Setup Mc Command
Test Goal
Verify that the TTY setups for the Board
Configuration section are properly configured for
the customer application.
Test Equipment
KVM installed
Test Procedure
1. Enter the TTY setups through dspx.
2. Issue the Mc command to display the internal status.
3. Set all the values, as required, for your operation.
Checklist
Table 92 Board
Configuration Checklist
Task Checked OK/Not OK Remarks
Test procedure completed successfully.
Appendix A – Installation and Test Procedures
345