Vaisala RVP900 - Using ddd on the Main & Proc Code

D.7.6 TS Archive Recording Quick Guide
1. Select a directory for the TS data to be written to.
Make sure the desired directory already exists in the file system.
2. Initialize the directory and give it a title. If the directory has already been used for
archiving, then there is no reason to re-initialize it unless you want the data to be
erased.
3. Select the data source and make sure the light is green.
4. Select Record and watch for data to arrive in the log section.
D.7.7 TS Archive Playback Quick Guide
1. Select the directory that contains the TS data to be played.
2. Under TS Source, select Local Archive.
3. Make sure the light is green.
4. Select the
files that you wish to playback (right-click and select Playback) and mark
them for playback.
5. Select any playback option.
6. Select Playback.
D.8
Ascope Playback Features
The Ascope utility is a stand-alone signal processor configuration and plotting utility. When
an RVP900 is in playback mode, you can use Ascope to
configure the processing of the
playback data and display the results. See IRIS and RDA Utilities Guide.
The following figure shows the dierences in the meanings of menu fields when RVP900 is
in playback mode.
RVP900 User Guide M211322EN-J
406