Vaisala RVP900 - Profiling with gprof; Creating New Major Modes from Old Ones

D.8.1 Archive on Local RVP900
Utility Settings
The support menus settings for archiving on a local RVP are:
• TS Switch: Local Archive
• TS Archive: Play
Network Note
In most cases, you are not sitting up at the radar, so you need to export the displays for
these utilities over the network by doing one of the following:
• Easy way: Use sigterm <hostname> to open a terminal window.
• Manually: rlogin and export the display with DISPLAY=<hostname>:0.0.
You may also need to type xhost + on your local workstation.
It is often convenient to get the playback going in tsarchive with Repeat set, then start
Ascope.
Ascope starts in the playback mode and updates the display appropriately. You are free to
select the data processing and display parameters
"on-the-fly" as playback is continuing and
repeating.
When Ascope is set the way that you want it, you can use the TS Archive menu to select
files or restart the playback.
D.8.2
Archive on Separate Archive Host
The utility settings for archiving on a separate archive host are:
RVP900:
• TS Switch: Network
• TS Archive: N/A
Archive Host:
• TS Switch: Local Archive
• TS Archive: Play
D.9
TS Playback Using IRIS
Successful playback of time series data requires IRIS version 8.09 or later and you must
make configure some settings in the IRIS user interface.
Table 120
Configuration Requirements for IRIS Playback
IRIS Location Setting
Ingest > Signal Processing
and Data Storage
Source of recorded angles = RVP Tags
Source of recorded time = RVP Tags
RVP900 User Guide M211322EN-J
408