• RVP902-WSP Processor attaches to the Ethernet switch using:
• 2 - 242525 DB9 M to DB9 F Null Modem Reverser Cable
• 1 - 220525 Ethernet Cable (Ethernet CAT5E)
• The RCP903-ASR9 WSP Interface Panel attaches to the Ethernet switch using:
• 1 - 220525 Ethernet Cable (Ethernet CAT5E).
• RVP901-WSP attaches to the Ethernet switch using:
• 1 - 231167 Ethernet Cable (Ethernet CAT5E).
• RVP901-WSP attaches to the Interface Panel using:
• 1 - Vaisala Cable CBL210393 for Data I/O interface.
• The External 24 volt power supply attaches to the RCP903 ASR9 Interface panel using:
• 1 - CBL210355, a DC power cable with a 9 pin DB connector.
CBL210393 is an I/O interconnect cable with a 51-pin micro “D” connector for connecting to
RVP901-WSP. This interconnect cable has a standard 62-pin female “D” connector to attach
to the Interface Panel. The standard cable length is 3 m. If the length of the CBL210393 cable
needs to be extended, a cable with good isolation between the twisted signal pairs to
maintain signal integrity, guarantee valid logic levels on TTL signals, and low noise analog
signal, are provided by Vaisala. The current cable meets the MIL-DTL-22759/11
specification,
which is insulated with PTFE.
CBL210355 is a DC power cable with a 9 pin “D” connector for connecting to the Interface
panel and an Unmanaged Ethernet Switch. If the length of the CBL210355 cable needs to be
extended, a cable with good isolation between the twisted power pairs is provided by
Vaisala.
220525 Ethernet Cable is a CAT5E cable to connect to the Panel through a network switch
or directly from the RVP902-WSP processor.
231167 Ethernet Cable is a CAT5E cable to connect to RVP901-WSP.
G.6.2
RVP901-WSP to ASR9 Radar
Table 127 RVP901-WSP Interface to ASR9 Radar
Signal RVP901-WSP Connector
COHO
J7
COHO
J13E
IF
J13A (31.07 MHz)
RVP901-WSP is configured with the AC Option and with 2 - 30 MHz filters specified.
Table 128 RVP901-WSP SMA Connector Summary
J-ID Label Type Description Use
J7
CLK IN
SMA Reference clock input
J8
TRIG-B
SMA General purpose trigger I/O --
RVP900 User Guide M211322EN-J
440
To Next Page
Loading...