Periodic Maintenance For Pump and Cart
1. If automatic air line oiler is not installed, periodically lubricate air line using SAE No.
10 oil.
2. Lubricate wheel bearings using quality wheel bearing grease.
3. Refer to the OTC Form 105001 and 100424 included with your hydraulic pump
(5012) for periodic maintenance requirements on the PA6-2-M.
4. Slowness or difficulty in returning piston assembly (5001-3) to the bottom of the
cylinder indicates the need to change hydraulic fluid and clean filter assembly
(29682) referred to in Form 100424 item 12.
Recommended Storage Procedures
Follow the steps below for proper storage when the QS-5000-C is out of service for an
extended period of time.
1. It is recommended to remove any product from the sealant cylinder.
2. Blow the piston down to the bottom of the sealant cylinder.
3. Coat the inside of the cylinder with a light oil. This should allow the piston to run
smoothly when you take it out of storage. When you are ready to use the unit, make
sure the hydraulic fluid is clean before you operate it. If it is not, change the
hydraulic fluid.
To Next Page
Loading...