22 FR
Using the appliance
B
Setting the salt consumption
• This dishwasher is designed to allow the amount of salt used to be adjusted according to
the hardness of the water. This function allows you to optimise and adapt the level of salt
consumption.
• Please follow the steps below to set the salt consumption:
1. Open the appliance door and switch on the appliance.
2. Within 60 seconds of powering up the appliance, press the "Programmes" button for more
than 5 seconds to enter the water softener setting mode.
3. Press the "Programmes" button to select the correct setting for your local environment.
The order in which the settings are displayed is as follows:
H1 -> H2 -> H3 -> H4 -> H5 -> H6.
4. Wait 5 seconds or press the power button to confirm the setting and exit the setting mode.
WATER HARDNESS
Setting
the water
softener
Salt
consumption
(grammes/
cycle)
German
degrees °dH
French
degrees
°fH
English
degrees
°Clark
Mmol/l
0 - 5 0 - 9 0 - 6 0 - 0.94 H1 0
6 - 11 10 - 20 7 - 14 1.0 - 2.0 H2 9
12 - 17 21 - 30 15 - 21 2.1 - 3.0 H3 12
18 - 22 31 - 40 22 - 28 3.1 - 4.0 H4 20
23 - 34 41 - 60 29 - 42 4.1 - 6.0 H5 30
35 - 55 61 - 98 43 - 69 6.1 - 9.8 H6 60
1 °dH = 1.25 °Clark = 1.78 °fH = 0.178 mmol/l
Factory setting: H3
Contact your local water company for information on the hardness of your water.
NOTE : Please refer to the chapter “Loading salt into the water softener”, if your
dishwasher runs out of salt.
To Next Page