VALBERG FL3 - Powering Off and Mode Switching

10
EN
<140º
Power off the Floorwasher
• Press the On/Off button on the handle.
Switch modes
1. While the Floorwasher is powering on and cleaning the floor, you can press on the
handle to switch to Power mode .
NOTE: Standard mode is the default mode.
2. Press on the handle to switch the cleaning mode between Standard mode and
Power mode .
CAUTION: Do not use the Floorwasher to clean surface with foam liquid. It is
recommended using Power mode for tougher dirts and stains.
• Currently selected mode will be shown on the display panel.
Clean the dirty water cup
NOTE:
• After using the Floorwasher, check the suction nozzle regularly and clean the
dirty water cup timely to keep the air tunnel unblocked so as to prevent from
any blockages that might cause suction dropping and motor overheating, thus
affecting the performance and service life of the product.
Product usage
B