VALBERG WF 1014 A W180C3 - Connecting the water inlet hose

11 EN
Using the appliance
B
Connecting the water inlet hose
9. If the water inlet hose is not already installed, it must be screwed into the washing machine.
The hose with the blue mark is for supplying cold water only.
Cool
10. Screw the inlet hose onto the tap by hand and tighten the nut.
CAUTION:
Ǫ(SRSXQEOIEORSXMRXLILSWI
Ǫ8LI[EWLMRKQEGLMRIQYWXRSXFIGSRRIGXIHXSXLI
mixer tap of a non-pressurised water heater.
Ǫ'LIGOXLEXXLIGSRRIGXMSRWEVI[EXIVXMKLXF]XYVRMRK
the water tap on fully.
Ǫ-JXLILSWIMWXSSWLSVXVITPEGIMX[MXLETVIWWYVI
resistant hose of adequate length (1000 kPa min,
compliant with the EN 50084 standard).
Ǫ6IKYPEVP]GLIGOXLIMRPIXLSWIJSVER][IEORIWWSV
cracks, and replace it if necessary.
Ǫ8LI[EWLMRKQEGLMRIQE]FIGSRRIGXIH[MXLSYXE
non-return valve.