VALBERG WF 1014 A W180C3 - After-sales service; Transport;handling; Electrical connection

43 EN
Useful information
C
After-sales service
Transport/handling
Electrical connection
Before calling the after-sales service:
1. Try to resolve the problem on your own (see the "Troubleshooting Guide" section).
2. Restart the program to check that the problem has been resolved.
3. If the problem persists, call the after-sales service.
Never lift the appliance by the worktop when transporting it.
1. Disconnect the plug.
2. Close the water tap.
3. Disconnect the inlet and drain hoses.
4. Remove any water trapped in the pipes and in the appliance (see the "Removing the filter"
and "Draining residual water" sections).
5. Fit the transit bolts (required).
6. Given that the machine weighs more than 55 kg, two people are needed to move it.
Make sure that the outlet has an earth connection.
Ǫ(SRSXYWIQYPXMWSGOIXWSVI\XIRWMSRGSVHW.
Ǫ8LITS[IVWYTTP]QYWXFIGSQTEXMFPI[MXLXLIVEXIHGYVVIRXSJXLIETTPMERGIM.e. 10 A.
Ǫ8LIIPIGXVMGEPGSRRIGXMSRWQYWXFIQEHIMREGGSVHERGI[MXLXLIPSGEPVIKYPEXMSRWMRJSVGI.
Ǫ8LIIPIGXVMGGEFPIQYWXSRP]FIVITPEGIHF]EUYEPMJMIHIPIGXVMGMER.
41