11 EN
Connect the drain hose
In case the drain hose is installed as shown below:
1. Unhook it only from the right clip (see arrow)
2.
Connect the drain hose to the Drain or hook it over the edge of a sink by means of the
“U” bend.
Fit the “U” bend E, if not already installed, at the end of the drain hose.
Notes:
• Ensure that there are no kinks in the drain hose.
• Secure the hose so that it cannot fall down. After wash phase, machine will
drain out hot water.
• Small hand basins are not suitable.
•
To make an extension use a hose of the same type and secure the connections
with clips.
• Max. Overall drain hose length: 2.50 m.
Product usage
B
To Next Page
Loading...
