11
Connect the drain hose
If the drain hose is already installed as in the diagram below.
1. Unhook it from the right-hand clip only (see arrow).
2. Connect the drain hose to the siphon or fasten it to the edge of a sink using the U-bend.
If it is not already installed, attach the U-bend (E) to the end of the drain hose.
Notes:
• Make sure that the drain hose is not kinked.
• Secure the hose so that it cannot fall. After the washing phase, the machine
drains the hot water.
• Small washbasins are not suitable for this purpose.
•
To lengthen the pipe, use a pipe of the same type and secure the fittings
with clips.
• Max. overall length of the drain hose: 2.50 m.
Electrical connection
• Make sure that the outlet has an earth connection.
• Do not use multi-sockets or extension cords.
• The power supply must be compatible with the rated current of the appliance, i.e. 10 A.
• The electric cable must only be replaced by a qualified electrician.
•
The electrical connections must be made in accordance with the local regulations in force.
Product usage
B
To Next Page
Loading...
Need help?
General