6
EN
Regulatory guidelines
6
EN
Regulatory guidelines
sliding door or a door with a hinge on the side opposite that of
the appliance, thus preventing the appliance from fully opening.
WARNING : Remove the transit bolts at the rear of the
appliance. These transit bolts are only needed when
transporting the appliance and must be removed before
the appliance is used for the first time, at the risk of
causing damage that is not covered by the warranty.
WARNING : The appliance must be connected to a mains
socket with a protective earth connection. The appliance
must not be connected via an extension cable or power
strip.
WARNING : Do not bend, crush or pinch the power supply
cable and the water pipes behind the appliance. Leave
enough space behind the appliance so that it is not in
direct contact with the mains socket, the water inlet or
drain.
CAUTION: The power to the appliance must not pass
through an external switch, like a timer, or be connected
to a circuit that is regularly turned on and off by the
utility provider.
To Next Page
Loading...
