46 47
EN EN
Useful information Useful information
B B
Problem Cause Solution
The laundry remains wet at
the end of the programme.
(*)
Too much foam may have
formed and the automatic
foam absorption system
may have been activated
due to excessive use of
detergent.
• Use the recommended
amount of detergent.
(*) The machine does not go to the spinning phase when the laundry is not evenly
distributed in the drum to prevent damage to the machine and its environment. The laundry
must be spread out again inside the drum and spun again.
(**) The drum is not cleaned regularly. Clean the drum regularly. Refer to section 4.4.2
WARNING: If you are unable to solve the problem despite following the instructions
in this section, contact the store or an authorised service agent. Never attempt to repair a
damaged unit yourself.
To Next Page
Loading...
