Valeton CP-200 - Guitar Amp FX Loop Connections

18
With guitar amps (using FX Loop to pre-position the GP-200)
In this scenario, connect the unbalanced output jacks of the GP-200 to the RETURN jacks of the guitar amp.
This way, by bypassing the preamp and using the power amp to pair with dozens of refined eects in the AMP module,
you’ll get the more realistic sound.
If only one amp is available, please select the L (MONO) first.
To get the best tone performance, keep the CAB module o or turn on the "No CAB" mode to avoid adverse eects on the
tone.
With guitar amps (using FX Loop to post-position the GP-200)
In this scenario, all modules before the AMP (including the AMP module) will be muted, and the eect chain after the
AMP module will be applied between the preamp and the power amp.
In order to get the best tone performance, keep the CAB module o or turn on the "No CAB" mode to avoid adverse
eects on the tone.
In addition, you need to pay attention to the GP-200’s level meter indication, if you hear the “clip” sound, please reduce
the input volume in the "Global - Input/Output”, or adjust the input to Line to try get the more ideal tone.
Application Scenarios