Valeton GP-200R - Connecting to Your Amps RETURN; Connecting Your Mixer, Interface, Headphones, and Other Equipment

To Next Page

To Previous Page

Suggested Setups

Connecting to your amp's RETURN

Connect the outputs to your amp’s FX Loop Return input. If you have one amp, run the cable from the left output.

For best results, turn o the CAB module on GP-100.

Connecting your mixer, interface, headphones, and other equipment

Connect GP-100’s outputs to your mixer or audio interface’s corresponding inputs. If you want to send a mono

signal out, use GP-100’s left output channel. To prevent damage to your equipment, make sure the mixer or

interface channel’s volume is muted before making ANY connections. Turn theGP-100 output volume all the

way down before connecting headphones to prevent harm to your ears. GP-100’s headphones out comes with

stereo sound.

For best results with headphones, turn on GP-100’s AMP and CAB modules.