Need help?Do you have a question about the Valmet K17122 and is the answer not in the manual?
General| Brand | Valmet |
|---|---|
| Model | K17122 |
| Category | Industrial Equipment |
| Language | English |
Caution regarding hot sample lines and dangers of incorrect electrical connections or welding.
Describes the different Valmet Microwave Consistency Measurement (Valmet MCA) sensor models.
Explains the working principle of the sensor based on microwave propagation time.
Describes the physical structure and components of the FT sensor model.
Describes the physical structure and components of the TB sensor model.
Guidelines for selecting the appropriate sensor model based on pipe size and flange standards.
Requirements and considerations for selecting the optimal installation location for the sensor.
Illustrates recommended and prohibited installation sites for the FT sensor model.
Illustrates recommended and prohibited installation sites for the TB sensor model.
Instructions for mechanically mounting the operating terminal, considering vibration and height.
Checks for delivery content and device integrity after transport.
Guidance on installing the sensor and operating terminal, with a warning about high voltage.
Checks for correct power, current output, and sensor cable connections.
Checks electronics connection to power and selection switch position.
Overview of the main user interface panels: control, menu, main view, and status.
Configuration of general device settings like timezone and time.
Explanation of the Recipe function for managing different measurement conditions.
Explains situations where advanced calibration is needed for precise measurement tuning.
Monitoring online measurement sampling, sequences, alarms, and errors via graphs.
Identifies common issues like air, chemicals, temperature, antenna contamination, and sensor electronics failures.
Performing tests on current outputs by setting them to test mode.
Adjusting sensor-specific parameters for optimal measurement performance.
Step-by-step instructions for removing and installing sensor electronics for TB and FT models.
To Next Page
