Scanning using only a Holder
If you will be scanning using only the Holder, we recommend you attach
the included rubber dome feet to each corner of the bottom of the Holder
to keep it stable during the scanning process. See assembly instructions.
1. Select the appropriate Holder and place it on your light source.
2. Insert lm in the direction shown, with the VALOI marking on the side
you insert the lm. While moving the lm in the Holder we recom-
mend pushing down on the holder lightly with one nger while mov-
ing the lm with the other to prevent the holder from moving.
3. Line up the rst frame you want to scan so you can see the whole
frame (as shown on page 34). Make sure you have focused and framed
properly, then scan your rst image.
4. To move to the next image, hold the holder down with one or two
ngers, then use your other hand to drag the lm to the next frame
you want to scan. Make sure to let go of the holder completely
before you take your picture, to minimise vibrations.
5. Repeat until you have nished scanning your strip or roll.
To Next Page
Loading...