Now place the Advancer on your light source and place the appropriate
Holder in the Advancer. The VALOI Logo should be on the side opposite
to the axles.
Ensure that the lm and camera are parallel by adjusting your copy stand
or using the Advancer’s leveling feet. Insert a piece of lm to the rst
frame, using it to compose and focus.
Once you are ready, scan the rst frame. Continue pushing the lm
through until you get to the next frame. If your lm does not have a
leader (blank unexposed lm at the end) you will scan your second frame
without the lm touching the rollers - that is ne.
After placing the lm close to the rollers, rotate the knob while pushing
the lm lightly against them using your other hand - the lm will catch.
Now you can use the knob to advance to each frame without touching the
lm with your ngers.
To Next Page
Loading...