The Film Holder lifts out of the
Advancer
This can happen if your lm is very
curly. Put a nger on the Holder
when moving the lm to press it
down
The lm is getting stuck in the
holder when trying to push it
through
Make sure the lm is emulsion-side
down, not up. Our testing shows
this does not inuence the scan-
ning result and will ensure the
lm goes through smoothly. If you
continue having problems (caused
by very curly lm), atten your
lm under some books for a few
days or use a nger to help the lm
through.
Problem Solution
To Next Page
Loading...