Using remote control
1. Pull out the battery holder.
Follow the arrow 1 slide it to the right toward the battery while at the same
time pull the battery holder away from the remote control.
2. Place the battery.
Place the new lithium battery with the (+) side up. (The type of battery:
Crd2025)
3. Push the holder back.
Using the finger to push in the holder back until the locking sound is heard.
4. Aim the IR Remote Control directly at the DVD player, then press any button.
§ Use the remote control only inside the vehicle
§ Use the IR Remote Control no further than five feet (3 meter) from
the sensor.
§ Direct sunlight or very bright light reduces sensitivity to the remote
signal commands. Be sure the player is not located in direct
sunlight.
§ Any obstruction between the remote sensor and remote control
may disrupt reception.
15
To Next Page
Loading...