Using FM transmitter
To use the FM transmitter for audio:
1. Press and hold MENU on the remote control for more than one second. The
Operation MENU opens.
2. Press MENU repeatedly to select FMT Freq, then press the < and > buttons
to change the frequency.
3. Exit the menu.
4. Tune your FM radio to match the frequency to the frequency you set in step
2 .Audio from the player is received by the FM radio.
Using the OSD menu
Press SETUP on the remote control, the OSD menu opens.
Menu
Description
TV DISPLAY: modifies the display if it doesn’t match the width to
height ratio the DVD uses. You can select from the following:
·NORMAL/PS
·NORMAL/LB
·WIDE
ANGLE MARK: Selects a different angle if the back of the
DVD jacket contains a multiple angles icon. You can select ON
or OFF.
OSD LANG: Selects a language for DVD play menu. You can
select from following:
·ENGLISH ·FRENCH ·SPANISH·ITALIAN
CAPTIONS: Selects the caption for DVD play. You can select
ON or OFF.
SCREEN SAVER: Protects the screen if it paused about 5
minutes. You can select ON or OFF.
General setup page
LOGO TYPE: Selects different start LOGO picture. You can
select Default and LOGO Captured.
DOWNMIX: Applies to Dolby digital sound. You can select
from following:
·LT/RT ·STEREO
DUAL MONO: Selects the different channels of sound. You
can select from following:
·STEREO ·L-MONO ·R-MONO ·MIX-MONO
Speaker setup page
DYNAMIC: Selects the different rating level of dB. You can
select from following:
·FULL ·3/4 ·1/2 ·1/4 ·OFF
24
To Next Page
Loading...