Do you have a question about the VALPRO VP19R-HC and is the answer not in the manual?
Inspect goods prior to carrier departure and note any damage immediately.
Open and inspect contents with carrier if damaged; record damage with driver.
Notify carrier within 5 days for concealed damage and request inspection.
Keep all crating material until inspection is completed or waived.
Ensure strong floor, adequate ventilation, and proper clearance for unit placement.
Maintain proper airflow within the cabinet to prevent coil freeze-ups and ensure efficient cooling.
Ensure ample air access, avoid hot locations, and maintain clearances from walls/above.
Level the unit for proper door alignment and performance using adjustable feet.
Lock casters and allow 24 hours for oil to settle if unit is transported on its side.
Connect to the correct power source per amperage data, local codes, and NEC.
Details refrigeration cycles, defrost, and fan operation for refrigerators and freezers.
Explains the function of SET, DEF, UP, and DOWN buttons on the thermostat display.
Describes key combinations for locking, unlocking, and navigating the thermostat interface.
Indicates fan status: running, delayed, or after defrost.
Shows defrost status: enabled, in progress, or dripping.
Indicates compressor status: enabled, delayed, or in programming phase.
Used to view alarms or increase values in programming mode.
Used to view alarms or decrease values in programming mode.
Indicates when a temperature alarm has occurred.
Shows room temp, set points, or alarm codes.
Initiates a manual defrost cycle.
Displays setpoint, selects parameters, or confirms operations.
Steps to view current setpoint and adjust it using the control panel.
Procedure to manually initiate the defrost cycle for the unit.
How to lock the control panel to prevent accidental changes and how to unlock it.
Procedure to view recorded alarms and reset them using the SET key.
Instructions for cleaning interior/exterior with mild soap, water, or non-abrasive cleaners.
Recommended frequency and methods for cleaning condenser coils to maintain performance.
Guidelines for cleaning stainless steel to prevent discoloration and rust.
Cleaning and replacing door gaskets to ensure proper seal and prevent mildew.
How to tighten loose door hinges to prevent sagging and damage.
Troubleshooting condensate drain issues and ensuring proper drainage.
Electrical schematic for the Valpro VP19R-HC model.
Electrical schematic for the Valpro VP1R-HC model.
Electrical schematic for the Valpro VP2R-HC model.
Electrical schematic for the Valpro VP3R-HC model.
Electrical schematic for the Valpro VP1RG-HC model.
Electrical schematic for the Valpro VP2RG-HC model.
Electrical schematic for the Valpro VP19F-HC model.
Electrical schematic for the Valpro VP1F-HC model.
Electrical schematic for the Valpro VP2F-HC model.
Electrical schematic for the Valpro VP3F-HC model.
Electrical schematic for the Valpro VP1FG-HC model.
Electrical schematic for the Valpro VP2FG-HC model.
Electrical schematic for the Valpro VP3FDV-HC dual voltage model.
| Brand | VALPRO |
|---|---|
| Model | VP19R-HC |
| Category | Refrigerator |
| Language | English |
Loading...