4
Proceed with caution. Danger to
life!
Switch off the computer in which the product is to be installed and
all connected devices. Disconnect all devices from the mains
voltage and pull out the main AC power cord! Just turning off at the
on/off switch is not enough!
• Open your computer’s housing and carefully remove the cover.
• Look for a free 3.5’’ installation slot and remove the slot cover.
Often there is a metal shielding behind it, which has to be
removed first. With some casings, you have to unscrew this, with
others you have to break it out carefully. Depending on the casing,
you may have to remove the entire front cover first.
• Apart from the slot cover that is already mounted on the slot, the
scope of delivery includes two more front covers in different
colours. Depending on the existing computer housing, the slot
cover can easily be replaced by another one.
• Connect the 9-pin USB plugs to an internal USB ports on the
motherboard. It is imperative to observe the correct orientation
(see operating instructions for the motherboard) since a wrong
connection may damage both the motherboard and the
electronics of the 3.5“plug-in unit, loss of warranty (refer to below
photo)!
To Next Page
Loading...
Need help?
General