CONTROL PANEL QUICK START CONNECT TO A DEVICE
Flame
Light on/Off/Cycle Modes
Speaker
2.Connect to a Bluetooth enabled device
3.Begin listening!
Power
Tum the Speaker On/Off
Bluetooth
Activate Party Sync Mode
Plus
Next Song/Volume Up
Minus
Last Song/Volume Down
Play/Pause
Play/Pause the Song
Battery
Check the Battery Level
1.Power on the ( )
Note:
If you are connecting multiple speakers for the
first time, please follow the steps below to enter
Light
Modes: Flicker IPulsing ISolid
Single click the Flame ( ) button to
turn on & cycle through the modes.
Press and hold the Flame ( ) button
to turn off the light without cycling
through the modes.
2.Turn on the Bluetooth feature in your
device's settings.
4.Select "SY126" from the list of devices.Once
you hear the voice prompt "connected",you
are ready to begin streaming.This will be the
"Parent" speaker.
1.Press and hold the power （ ） button.
3.
If you are connecting this speaker for
the first time, you need to single click
the Bluetooth ( ) button first, you
will hear “dongdong” , then you can
find the Bluetooth device "SY126" on
your list; If you have already connect
ed this speaker, you don't need to
click Bluetooth ( ) button, it will
connect automatically.
Do you have more than one "SY126"?
Continue with steps 4-7!
User Manual
To Next Page
Need help?
General