Vaporesso APEX - Page 3

ENGLISH
1. Install & Replace the Pod
Pull out the pod from the battery and install the new
one.
*If it’s the rst time using the device, please tear off the
sticker of the pre-installed pod.
2. Fill the E-liquid (Refer to FIGURE 1)
- Take out the used POD from the battery and pull out
the silicone plug from the side of the POD;
- Fill e-liquid through the hole
- Put the silicone plug back in place rmly after lling is
nished.
*If it’s the rst time lling the e-liquid, please wait 5
minutes for the coil to prime.
3. Start Vaping
The device is both button-activated and draw-activated.
Press the power button or inhale directly through the
Drip tip and exhale to start vaping.
4.Adjust Airow
There is an airow control toggle on the side of the Pod.
Adjust the toggle according to your vaping habits for
different airow effects.
5. Puff Cleaned
Click the power button 2 times in 2s to enter the
interface, then click the power button to select, wait for
2s to conrm.
6. Power Settings
Click the power button 3 times in 2s to set the vaping
power, and click again to adjust the wattage.
7.Lock Button
Click the power button 4 times in 2 seconds to lock
the power button, and the Power ON/OFF function still
works.
8. Power ON/OFF
Click the power button 5 times in 2 seconds to power on
or power off the device.
9. Check the Battery Level
Check the battery level by clicking the power button or
inserting the pod to light up the screen.
10. Charging
Please use the in-box Type-C cable to charge the device.
The screen will play a charging animation with the
current charge.
USER INSTRUCTIONS
PROTECTIONS
Low Resistance/Short-circuit: The screen displays “LOW
RESISTANCE” and the device will stop working.
High Temperature: The screen displays “OVER HEAT”
and the device will stop working.