21 ENGLISH
Figure 1
1. Install & Replace the Pod
Pull out the pod from the battery and install the new
one.
*If it’s the rst time using the device, please tear off
the sticker of the pre-installed pod.
2. Fill the E-liquid (Refer to FIGURE 1)
Snap off the mouthpiece and ll the e-liquid through
the lling slot.
*If it’s the rst time lling the e-liquid, please wait 5
minutes for the coil to prime.
3. Start Vaping
The device is draw-activated. Inhale through the
mouthpiece and exhale to start vaping.
4. Check the Battery Level
5. Charging
Please use the in-box Type-C cable to charge the
device. The LED indicators will breath while charging
and stay on while fully charged.
60%-100%
30%-60%
0%-30%
USER INSTRUCTIONS
To Next Page
Loading...
