Need help?Do you have a question about the VARMEC RCV 1 Series and is the answer not in the manual?
General| Category | Industrial Equipment |
|---|---|
| Body Material | Stainless Steel |
| Type | Control Valve |
| Connection Type | Flanged |
| Actuator Type | Pneumatic |
| Control Signal | 4-20 mA |
| Series | RCV 1 Series |
Applicable power at input related to speed n1 and service factor FS=1.
Power transmitted at gear reducer output, calculable with formulas.
Torque transmitted at gear reducer output relating to speed n1 and n2.
Torque corresponding to application requirements.
Torque value used for gear reducer selection.
Ratio between input and output speeds.
Gear reducer efficiency values at full load after running-in.
Speed determined by motorisation type (n1) and reduction ratio (n2).
Used to determine the type of load, calculated from inertia values.
Indicates the gear reducer's thermic limit, preventing damage to internal components.
Steps to select an RCV motor reducer based on load type and service factor.
Procedure for selecting CV gear reducers and IEC motor reducers.
Instantaneous peak overloads must not exceed double the gear reducer's torque values.
Gear reducer's thermic power must be equal to or higher than the appliance's power needs.
Loads on input and output shafts must be within catalogue permissible limits.
Calculated radial load on input or output shafts, based on torque and diameter.
Axial load that can act simultaneously with radial load.
Specifies input and output shaft dimensions in millimeters.
Specifies input and output shaft dimensions in inches.
Diagrams showing assembly positions and terminal box orientation.
To Next Page
